Arduino PEN PLOTTER MACHINE USES:

Arduino PEN PLOTTER Machine and a CNC shield along with stepper motors and stepper motor drivers to enable the movement in x and y axis. i have used aluimnium profiles and 3d printed plates to provide structure to the machine. i have used belts and pulleys for linear motion from the motors to the plates. for power supply i have used a 12v 2A power adapter.

In Arduino PEN PLOTTER after powering the machine, you will have to connect it to a computer and use universal gcode sender software to send the gcodes to the machine. you can take any text or image file in inkscape and convert it into a gcode in very few and simple steps.

Once the gcode  is ready, open it in the universal gcode sender, connect the COM port of the arduino and you can start executing the file. you can also change the speed and acceleration of the machine in the firmware settings menu under the machine tab of the universal gcode sender

ITEM IN GIVEN PACKAGE:

1. NEMA 17 Stepper Motor:
2. A4988 Driver:
3. Arduino UNO
4. CNC shield
5. Servo MG90
6. 12V 2A Adapter
7. Rubber Feet Set
8. 2020 Profile
9. 2040 Profile
10. Fasteners
11. M5 sliding nut
12. GT2 Belt Pulley
13. Idler pulley:
14. V Wheel Set

CNC 3018,DIY Engraving Machine OR Pcb Milling Machine laser engraving GRBL control