2 Cell Power bank Housing Case

2 Cell Power bank DIY PBC1 Power bank housing with PCB of 2 cells 18650

DIY Power bank housing shell with PCB compartment for two cell, ever wonder to make your own high quality power bank insead purchasing from market low level fake capacities power bank, we have this power bank housing  with intelligent PCB to charge battery with buck converter and boost converter to recharge your mobile phone with 1 USB port and status Led.

2 Cell Power bank

1: 1 Status LED
2: Size 100x47x23 mm
3: 2x 18650 cell compartment
Note: All 3.7V 18650 cell must be connected in parallel to form 3.7V total and then wire them to PCB + to + positive and – to – Negative.
we would suggest you use 1500mAh or 2000mAh 18650 cell from Megatronics

PCB
single USB ouput, Suitable batteries for this PCB is 18650 with 1500 or 2000mAh capacity 3.7V (Battery not included)

1: Charge and discharge protection
2: built-in lithium battery protection IC on the circuit board
3: Over voltage protection,
4: Over current protection,
5: under voltage protection

Charging input requirements, 5V 1A, 2A or above.

Package contents:
1x Housing shell with parts
1x PCB

Note: No battery is included in this package, we will suggest you use 1500mAh or 2000mAh Megatronics 18650 cell.

 

10,000mAH Dual USB Port Ultra-Thin Power Bank Battery Backup